Active Standard ASTM F1018 | Developed by Subcommittee: F25.03
Book of Standards Volume: 01.07
Historical (view previous versions of standard)
This specification establishes the material and design requirements, as well as the mandatory dimensional and construction details for four types of steel emergency gear stowage lockers used for the stowage of one or two complete fireman's outfit(s).
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers the design, material, and manufacture of steel emergency gear stowage lockers.
1.2 Emergency gear lockers shall be of four types (see Section 3).
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A36/A36M Specification for Carbon Structural Steel
A276 Specification for Stainless Steel Bars and Shapes
A366/A366M Specification for Commercial Steel (CS) Sheet, Carbon, (0.15 Maximum Percent) Cold-Rolled
A513 Specification for Electric-Resistance-Welded Carbon and Alloy Steel Mechanical Tubing
A563 Specification for Carbon and Alloy Steel Nuts
B36/B36M Specification for Brass Plate, Sheet, Strip, And Rolled Bar
B124/B124M Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes
B176 Specification for Copper-Alloy Die Castings
ANSI StandardsANSIB27.2 Plain Washers
Other DocumentsAWSD1.1 Welding Code Available from American Welding Society (AWS), 550 NW LeJeune Rd., Miami, FL 33126, http://www.aws.org.
ICS Number Code 47.080 (Small craft)
UNSPSC Code 11101704(Steel)