ASTM E949-88(2004)

    Withdrawn Standard: ASTM E949-88(2004) Standard Test Method for Total Moisture in a Refuse-Derived Fuel Laboratory Sample (Withdrawn 2004)

    Developed by Subcommittee: D34.03

    WITHDRAWN, NO REPLACEMENT

    Buy Standard (PDF)
    4 pages
    $44.40


    Withdrawn Rationale:

    This test method covers the measurement of the total moisture in RDF as it exists at the time it is sampled. Because of its empirical nature, strict adherence to test procedures are required for valid results.

    Formerly under the jurisdiction of Committee D34 on Waste Management, this standard was withdrawn without replacement in July 2011 because of limited use by industry in light of analogous standards for coal.

    1. Scope

    1.1 This test method covers the measurement of the total moisture in RDF as it exists at the time it is sampled. Because of its empirical nature, strict adherence to test procedures are required for valid results. The standard is available to producers, vendors, and consumers as a total, two-stage moisture method.

    1.2 Since RDF can vary from extremely wet (water saturated) to relatively dry, special emphasis must be placed on sampling, sample preparation, and the method of determination.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For hazard statement, see Section .


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D3173 Test Method for Moisture in the Analysis Sample of Coal and Coke

    E790 Test Method for Residual Moisture in Refuse-Derived Fuel Analysis Sample

    E829 Practice for Preparing Refuse-Derived Fuel (RDF) Laboratory Samples for Analysis


    DOI: 10.1520/E0949-88R04

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top