WITHDRAWN, NO REPLACEMENT
| ||Format||Pages||Price|| |
|7||$54.00||  ADD TO CART|
This test method covered the determination of the energy and power requirements of processing equipment using an electrical metering system.
Formerly under the jurisdiction of Committee D34 on Waste Management, this test method was withdrawn in May 2014. This standard is being withdrawn without replacement due to its limited use by industry.
1.1 This test method covers the determination of the composition of a materials stream in a solid waste resource recovery processing facility. The composition is determined with respect to one or more defined components. The results are used for determining the purity resulting from the operation of one or more separators, and in conjunction with Test Method E1108 used to measure the efficiency of a materials separation device.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For hazard statements, see Section 7.
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM E929-83(2009), Standard Test Method for Measuring Electrical Energy Requirements of Processing Equipment (Withdrawn 2014), ASTM International, West Conshohocken, PA, 2009, www.astm.orgBack to Top