ASTM E465 - 11

    Standard Test Methods for Determination of Manganese (IV) in Manganese Ores by Redox Titrimetry

    Active Standard ASTM E465 | Developed by Subcommittee: E01.02

    Book of Standards Volume: 03.05


    Buy Standard (PDF)
    3 pages
    $37.00
    Buy Standard (Print)
    3 pages
    $37.00
    Buy Standard + Redline (PDF)
    6 pages
    $44.40

    Historical (view previous versions of standard)


    ASTM E465

    Significance and Use

    This test method is intended to be used for compliance with compositional specifications for manganese dioxide content in manganese ores. It is assumed that all who use these procedures will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory and that proper waste disposal procedures will be followed. Appropriate quality control practices shall be followed, such as those described in Guide E882.

    1. Scope

    1.1 These test methods cover the determination of manganese dioxide in amounts commonly found in manganese ore. The determination measures the amount of manganese (IV) present in the sample. The result may be expressed as available oxygen or as manganese dioxide. The following test methods are included and may be used interchangeably:

    Sections
    Test Method A (Ferrous Ammonium Sulfate) 9-13
    Test Method B (Periodate (Sodium Oxalate)14-18

    1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1193 Specification for Reagent Water

    E50 Practices for Apparatus, Reagents, and Safety Considerations for Chemical Analysis of Metals, Ores, and Related Materials

    E135 Terminology Relating to Analytical Chemistry for Metals, Ores, and Related Materials

    E882 Guide for Accountability and Quality Control in the Chemical Analysis Laboratory


    ICS Code

    ICS Number Code 73.060.20 (Manganese ores)

    UNSPSC Code

    UNSPSC Code 11101611(Manganese ore); 41115602(Titration equipment)


    DOI: 10.1520/E0465-11

    ASTM International is a member of CrossRef.

    ASTM E465

    Citing ASTM Standards
    Back to Top