| ||Format||Pages||Price|| |
|3||$40.00||  ADD TO CART|
|Hardcopy (shipping and handling)||3||$40.00||  ADD TO CART|
|Standard + Redline PDF Bundle||6||$48.00||  ADD TO CART|
Significance and Use
The procedures outlined here are grounded in the generally accepted body of knowledge and experience in the field of forensic document examination. By following these procedures, a forensic document examiner can reliably reach an opinion concerning whether two or more dry seal impressions have a common origin, or if a dry seal impression was created by a specific dry seal device.
1.1 This guide provides procedures that should be used by forensic document examiners (Guide E 444
1.2 These procedures are applicable whether the examination(s) and comparison(s) is of questioned and known items or of exclusively questioned items.
1.3 These procedures include evaluation of the sufficiency of the material available for examination.
1.4 The particular methods employed in a given case will depend upon the nature and sufficiency of the material available for examination.
1.5 This guide may not cover all aspects of particularly unusual or uncommon examinations.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
E444 Guide for Scope of Work of Forensic Document Examiners
E1658 Terminology for Expressing Conclusions of Forensic Document Examiners
E1732 Terminology Relating to Forensic Science
E2195 Terminology Relating to the Examination of Questioned Documents
ICS Number Code 03.160 (Law. Administration)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM E2286-08a, Standard Guide for Examination of Dry Seal Impressions, ASTM International, West Conshohocken, PA, 2008, www.astm.orgBack to Top