This technique produces a chemical-precipitation reaction between methamphetamine or amphetamine and the precipitating reagent. The habit and the aggregation of the crystals formed may be used to distinguish methamphetamine and amphetamine from other drugs.

1. Scope

1.1 This guide describes some standard procedures applicable to the analysis of methamphetamine and amphetamine using microcrystal tests (1-6).

1.2 These procedures are applicable to methamphetamine and amphetamine, which are present in solid dosage form or an injectable liquid form. These procedures are not typically applicable to the analysis of methamphetamine and amphetamine in biological samples.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard cannot replace knowledge, skill, or ability acquired through appropriate education, training, and experience and should be used in conjunction with sound professional judgment.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

E1459 Guide for Physical Evidence Labeling and Related Documentation

E1492 Practice for Receiving, Documenting, Storing, and Retrieving Evidence in a Forensic Science Laboratory

E1732 Terminology Relating to Forensic Science

E2329 Practice for Identification of Seized Drugs

E2548 Guide for Sampling Seized Drugs for Qualitative and Quantitative Analysis

Keywords

amphetamine; methamphetamine; microcrystalline testing; Forensic investigation/analysis; Methamphetamine; Amphetamine; Microcrystal testing; Skeletal crystal;

ICS Code

ICS Number Code 11.100 (Laboratory medicine)

Citing ASTM Standards

[Back to Top]