ASTM E1828-01

    Standard Practice for Evaluating the Performance Characteristics of Qualitative Chemical Spot Test Kits for Lead in Paint (Withdrawn 2010)

    Withdrawn Standard: ASTM E1828-01 | Developed by Subcommittee: E06.23

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF Version 6 $50.40   ADD TO CART


    Withdrawn Rationale:

    This practice describes an evaluation procedure for the determination of performance characteristics of qualitative chemical spot test kits for lead, as applied to dry paint films, for a given dry paint film matrix on a given substrate.

    Formerly under the jurisdiction of Committee E06 on Performance of Buildings, this practice was withdrawn in February 2010 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This practice describes an evaluation procedure for the determination of performance characteristics of qualitative chemical spot test kits for lead, as applied to dry paint films, for a given dry paint film matrix on a given substrate.

    1.2 This practice may be used to determine the performance characteristics of a given lead spot test kit for a given synthetic or field dry paint film matrix, independent of substrate effects.

    1.3 To allow for comparisons of different spot test kits on an identical matrix, this practice covers the determination of test kit performance characteristics on a synthetically prepared standard white lead-containing paint film. The ingredients for the preparation of a standard synthetic leaded paint film based on basic lead carbonate are described.

    1.4 This practice is not intended for the evaluation of performance parameters of chemical spot test kits on all types of paint or paint conditions that may be encountered during field use (as described in E 1753). Rather, this practice addresses the evaluation of the response of a chemical spot test kit for lead as a function of lead concentration for a limited set of paint films. Evaluating the performance of a chemical spot test kit for a given application requires tests on a representative sample of paints and substrates found at the location(s) to be tested.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D81 Specification for Basic Carbonate White Lead Pigment

    D823 Practices for Producing Films of Uniform Thickness of Paint, Varnish, and Related Products on Test Panels

    D1005 Test Method for Measurement of Dry-Film Thickness of Organic Coatings Using Micrometres

    E1605 Terminology Relating to Abatement of Hazards from Lead-Based Paint in Buildings and Related Structures

    E1613 Test Method for Determination of Lead by Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES), Flame Atomic Absorption Spectrometry (FAAS), or Graphite Furnace Atomic Absorption Spectrometry (GFAAS) Techniques

    E1645 Practice for Preparation of Dried Paint Samples by Hotplate or Microwave Digestion for Subsequent Lead Analysis

    E1729 Practice for Field Collection of Dried Paint Samples for Lead Determination by Atomic Spectrometry Techniques

    E1753 Practice for Use of Qualitative Chemical Spot Test Kits for Detection of Lead in Dry Paint Films

    Federal Specifications

    FederalSpecification Paint, Oil (Alkyd Modified, Exterior, White, and Tints)


    DOI: 10.1520/E1828-01

    ASTM International is a member of CrossRef.