This test method is primarily intended as a test for compliance with compositional specifications. It is assumed that all who use this test method will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that the work will be performed in a properly equipped laboratory.

1. Scope

1.1 This test method covers the determination of oxygen in titanium and titanium alloys in concentrations from 0.01 % to 0.5 % and the determination of nitrogen in titanium and titanium alloys in concentrations from 0.003 % to 0.11 %.

1.2 The values stated in both inch-pound and SI units are to be regarded separately as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 8.8.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Index Terms

inert gas fusion; oxygen; titanium; titanium alloys; Oxygen content--Ti/Ti alloys; Inert gas fusion; Titanium alloys; Titanium (Ti)/alloys;

ICS Code

ICS Number Code 77.120.50 (Titanium and titanium alloys)

Citing ASTM Standards

[Back to Top]