ASTM D984-97(2007)

    Standard Test Methods for Reducible Sulfur in Paper (Withdrawn 2010)

    Withdrawn Standard: ASTM D984-97(2007) | Developed by Subcommittee: D06.92

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 5 $51.60   ADD TO CART


    Withdrawn Rationale:

    These test methods cover the determination of reducible sulfur in paper and paperboard within the context of the given definitions.

    Formerly under the jurisdiction of Committee D06 on Paper and Paper Products, these test methods were withdrawn in August 2010 because an equivalent TAPPI publication exists.

    1. Scope

    1.1These test methods cover the determination of reducible sulfur in paper and paperboard within the context of the given definitions.

    1.1.1Method AThe quantitative method gives a measure of the reducible sulfur with much greater accuracy. ,

    1.1.2 Method BThe semiquantitative method indicates the general level of reducible sulfur with limited accuracy.

    1.2This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D585 Practice for Sampling and Accepting a Single Lot of Paper, Paperboard, Fiberboard, and Related Product

    D644 Test Method for Moisture Content of Paper and Paperboard by Oven Drying

    D1968 Terminology Relating to Paper and Paper Products

    D2043 Test Method for Silver Tarnishing by Paper


    Referencing This Standard

    DOI: 10.1520/D0984-97R07

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D984-97(2007), Standard Test Methods for Reducible Sulfur in Paper (Withdrawn 2010), ASTM International, West Conshohocken, PA, 2007, www.astm.org

    Back to Top