Abstract
This specification covers the requirements for thirteen grades of emulsified asphalt for use in pavement construction in the manner designated. The emulsified asphalts shall be homogeneous after thorough mixing and shall be tested within 14 days of delivery. Asphalts separated by freezing shall no longer be tested. Materials shall be appropriately sampled and tested, and shall conform accordingly to the following physical requirements: viscosity; storage stability; demulsibility; coating ability and water resistance; cement mixing; residue by distillation; oil distillate; ductility; solubility in trichloroethylene; and behavior during sieve, penetration, and float tests.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers thirteen grades of emulsified asphalt for use in pavement construction in the manner designated.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D5 Test Method for Penetration of Bituminous Materials
D113 Test Method for Ductility of Bituminous Materials
D139 Test Method for Float Test for Bituminous Materials
D140 Practice for Sampling Bituminous Materials
D244 Test Methods and Practices for Emulsified Asphalts
D2042 Test Method for Solubility of Asphalt Materials in Trichloroethylene
D3910 Practices for Design, Testing, and Construction of Slurry Seal
D6930 Test Method for Settlement and Storage Stability of Emulsified Asphalts
D6933 Test Method for Oversized Particles in Emulsified Asphalts (Sieve Test)
D6935 Test Method for Determining Cement Mixing of Emulsified Asphalt
D6936 Test Method for Determining Demulsibility of Emulsified Asphalt
D6997 Test Method for Distillation of Emulsified Asphalt
D7496 Test Method for Viscosity of Emulsified Asphalt by Saybolt Furol Viscometer
D7553 Test Method for Solubility of Asphalt Materials in N-Propyl Bromide
Keywords
emulsion; emulsified asphalt; high float; medium setting; rapid setting; slow setting;
ICS Code
ICS Number Code 91.100.50 (Binders. Sealing materials); 93.080.20 (Road construction materials)
DOI: 10.1520/D0977-12B
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
