ASTM D866-99(2004)

    Standard Specification for Crosslinked Styrene-Butadiene (SBR) Synthetic Rubber Jacket for Wire and Cable (Withdrawn 2009)

    Withdrawn Standard: ASTM D866-99(2004) | Developed by Subcommittee: D09.18

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 1 $45.60   ADD TO CART


    Withdrawn Rationale:

    This specification covers a crosslinked styrene-butadiene (SBR) synthetic rubber compound suitable for use as the outer covering or jacket on insulated electrical wires or cables for heavy-duty service.

    Formerly under the jurisdiction of Committee D09 on Electrical and Electronic Insulating Materials, this specification was withdrawn without replacement in 2010 because there is no indication that this specification is being used in the industry.

    1. Scope

    1.1 This specification covers a crosslinked styrene-butadiene (SBR) synthetic rubber compound suitable for use as the outer covering or jacket on insulated electrical wires or cables for heavy-duty service.

    1.2 This jacket is not recommended for installation at a temperature lower than 35 °C.

    1.3 Whenever two sets of values are presented, in different units, the values in the first set are the standard, while those in parentheses are for information only.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D470 Test Methods for Crosslinked Insulations and Jackets for Wire and Cable

    D1711 Terminology Relating to Electrical Insulation


    Referencing This Standard

    DOI: 10.1520/D0866-99R04

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D866-99(2004), Standard Specification for Crosslinked Styrene-Butadiene (SBR) Synthetic Rubber Jacket for Wire and Cable (Withdrawn 2009), ASTM International, West Conshohocken, PA, 2004, www.astm.org

    Back to Top