This test method is suitable for setting specifications, for use as an internal quality control tool, and for use in development or research work on industrial aromatic hydrocarbons and related materials. This test method gives an indication of residual acidity and is a measure of the quality of the finished product. It is an indication of the tendency of the product to corrode equipment.

1. Scope

1.1 This test method is intended for the detection of acidity and for the quantitative determination of acidity of benzene, toluene, xylenes, solvent naphthas, and similar industrial aromatic hydrocarbons.

1.2 In determining the conformance of the test results using this method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E 29.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 8.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Other Documents

Keywords

acidity; aromatic hydrocarbons; Acidity, alkalinity, pH--paints/related coatings/materials; Benzene--paints/related coatings/materials; Distilled water; Industrial aromatic hydrocarbons; Naphtha and naphtha derivatives; Solvent naphthas; Toluene; Xylene ;

ICS Code

ICS Number Code 71.080.15 (Aromatic hydrocarbons)

Citing ASTM Standards

[Back to Top]