Active Standard ASTM D7882 | Developed by Subcommittee: D16.02
Book of Standards Volume: 06.04
Significance and Use
5.1 The presence of 4-CBA and p-TOL in PTA used for the production of polyester is undesirable because they can slow down the polymerization process; and 4-CBA is also imparting coloration to the polymer due to thermal instability.
5.2 Determining the amount of 4-CBA and p-TOL remaining from the manufacture of PTA is often required. This test method is suitable for setting specifications and for use as an internal quality control where these products are produced or used.
5.3 This test method is intended as an alternative to the HPLC method for determination of 4-CBA and p-TOL in PTA. The major benefits of CE are speed, simplicity, reduced reagent consumption and operating costs.
1.1 This test method covers the determination of 4-carboxybenzaldehyde (4-CBA) and p-toluic acid (p-TOL) in purified terephthalic acid (PTA) by capillary electrophoresis (CE) with normal voltage mode and UV detection. It is applicable for 4-CBA from 5 to 400 mg/kg and for p-TOL from 10 to 400 mg/kg, respectively.
1.2 In determining the conformance of the test results using this method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E29.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Other DocumentOSHA Regulations 29 paragraphs 1910.1000 and 1910.1200
ISO DocumentEN ISO 8213 Chemical Products for Industrial Use--Sampling Techniques--Solid Chemical Products in the Form of Particles Varying from Powders to Coarse Lumps
D1193 Specification for Reagent Water
D4790 Terminology of Aromatic Hydrocarbons and Related Chemicals
D6809 Guide for Quality Control and Quality Assurance Procedures for Aromatic Hydrocarbons and Related Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ICS Number Code 71.080.40 (Organic acids)