Standard Active Last Updated: Oct 10, 2019 Track Document
ASTM D7834-13(2019)

Standard Test Method for Filling Material Shedding of Paint Brushes

Standard Test Method for Filling Material Shedding of Paint Brushes D7834-13R19 ASTM|D7834-13R19|en-US Standard Test Method for Filling Material Shedding of Paint Brushes Standard new BOS Vol. 06.02 Committee D01
$ 55.00 In stock

Significance and Use

3.1 During the application of coatings, paint brushes can exhibit shedding of filling material onto the coated surface. A measure of this shedding filling material will determine the paint brush’s ability to resist shedding during application.

Scope

1.1 This test method describes the procedure for testing the shedding properties of both natural bristle and synthetic filament paint brushes (referred as filling material).

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 06.02
Developed by Subcommittee: D01.61
Pages: 2
DOI: 10.1520/D7834-13R19
ICS Code: 87.100