This specification specifies test methods which measure minimum qualities for acrylic dispersion grounds. It indicates the conditions that affect the quality of acrylic dispersion grounds that are not covered in the specification, such as wet ground properties, dry properties, and storage. This specification also mentions several methods that are used to test some of these conditions, including adhesion, oil hold out, and flexibility.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This standard specifies test methods which measure minimum qualities for acrylic dispersion grounds.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

acrylic; dispersion polymer; gesso; ground; oil hold out; polymer; primer;

ICS Code

ICS Number Code 87.040 (Paints and varnishes)

Citing ASTM Standards

[Back to Top]