ASTM D7611 / D7611M - 13e1

    Standard Practice for Coding Plastic Manufactured Articles for Resin Identification

    Active Standard ASTM D7611 / D7611M | Developed by Subcommittee: D20.95

    Book of Standards Volume: 08.03


      Format Pages Price  
    PDF 4 $38.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $38.00   ADD TO CART


    Significance and Use

    4.1 Resin Identification Codes are used solely to identify the plastic resin used in a manufactured article.

    4.2 Resin Identification Codes are not “recycle codes.” The use of a Resin Identification Code on a manufactured plastic article does not imply that the article is recycled or that there are systems in place to effectively process the article for reclamation or re-use. The term “recyclable” or other environmental claims shall not be placed in proximity to the Code.

    4.3 This practice is based upon the system developed in 1988 by the Society of the Plastics Industry, Inc (SPI). It is possible that some states or countries will have incorporated the original SPI practice into statute or regulation. In those situations, that statute or regulation takes precedence over this standard.

    4.4 This practice shall only apply to new tooling. Existing molds that already incorporate older versions of the SPI RIC may be modified, but modification is not required.

    1. Scope

    1.1 This practice stipulates the types, names, and sizes of Codes for those material types specified in Table 1.

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are likely not to be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems is likely to result in non-conformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 1: There is no known ISO equivalent to this standard.


    ICS Code

    ICS Number Code 83.140.01 (Rubber and plastic products in general)

    UNSPSC Code

    UNSPSC Code


    DOI: 10.1520/D7611_D7611M-13E01

    ASTM International is a member of CrossRef.

    ASTM D7611 / D7611M

    Citing ASTM Standards
    Back to Top