ASTM D7256/D7256M-08

Withdrawn Rationale:

This practice covers procedures for the mechanical collection of a sample under Classification I-B-1 and I-B-2 (Practice D 2234/D 2234M) and the within-system preparation (reduction and division) of gross samples utilizing various components of the mechanical sampling system.

Formerly under the jurisdiction of Committee D05 on Coal and Coke, this practice was withdrawn in October 2008 and replaced by Practice D 7430 for Mechanical Sampling of Coal

1.1 This practice covers procedures for the mechanical collection of a sample under Classification I-B-1 and I-B-2 (Practice D 2234/D 2234M) and the within-system preparation (reduction and division) of gross samples utilizing various components of the mechanical sampling system.

1.2 This practice describes mechanical sampling procedures for coals (1) by size and condition of preparation (for example, mechanically cleaned coal or raw coal) and (2) by sampling characteristics.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, use each system independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

coal; coal sampling; mechanical sampling; sample division; sample reduction; Coal/coke products; Coal sampling systems; Mechanical sampling systems; Sampling coal/coke;

Citing ASTM Standards

[Back to Top]