ASTM D7233 - 08(2012)

    Standard Test Method for Testing Fracture of Level Paintbrush Filaments

    Active Standard ASTM D7233 | Developed by Subcommittee: D01.61

    Book of Standards Volume: 06.02


      Format Pages Price  
    PDF 3 $38.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $38.00   ADD TO CART


    Significance and Use

    3.1 This method is intended to evaluate filaments for suitability of use in paintbrushes prior to manufacture. Filament fracture resistance is very important because paintbrushes are bent or flexed during painting and it is necessary that the filaments are not permanently deformed with usage.

    1. Scope

    1.1 This test method covers a procedure for determining the number of fractures present when paintbrush filaments are bent.

    1.2 This method is applicable only to monofilaments with consistent longitudinal cross sectional dimensions commonly referred to as “level” filaments.

    1.3 The values derived are in percent fractured filaments. For example, 2 fractured out of 18 filaments tested = 2/18 or 11 %.

    1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    ICS Code

    ICS Number Code 87.100 (Paint coating equipment)

    UNSPSC Code

    UNSPSC Code 31211904(Paint brushes)


    Referencing This Standard

    DOI: 10.1520/D7233-08R12

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D7233-08(2012), Standard Test Method for Testing Fracture of Level Paintbrush Filaments, ASTM International, West Conshohocken, PA, 2012, www.astm.org

    Back to Top