ASTM D7036 - 12

    Standard Practice for Competence of Air Emission Testing Bodies

    Active Standard ASTM D7036 | Developed by Subcommittee: D22.03

    Book of Standards Volume: 11.07


    Buy Standard (PDF)
    10 pages
    $42.00
    Buy Standard (Print)
    10 pages
    $42.00
    Buy Standard + Redline (PDF)
    20 pages
    $50.40

    Historical (view previous versions of standard)


    ASTM D7036

    Significance and Use

    4.1 This Practice establishes general criteria for a Quality System that, when followed, helps ensure consistently acceptable data quality from an AETB. The relevant criteria contained in this Practice shall be addressed in the AETB’s Quality Manual, which shall contain or refer to additional specific criteria and requirements where relevant and necessary. The Quality Manual and its implementation (including test protocols, reports, and personnel testing) shall provide the sole basis for determining the conformance of the AETB with this standard.

    Note 3This Practice assesses the overall ability of an AETB to deliver data of known and documented quality on a consistent basis regardless of the test method used. There is no requirement to define a scope of testing. It is a requirement of this Practice that prior to performing a test method for the first time, the AETB has in place resources, training, and QA/QC consistent with this Practice to insure data of acceptable quality are produced.

    4.2 This Practice is for use by AETBs in developing the quality, administrative, and technical systems that govern their operations. Clients, regulatory authorities, and accreditation bodies may also use it in confirming or recognizing the competency of AETBs.

    Note 4This Practice is performance-based; that is, it focuses on the actual performance (i.e., consistent generation of data of known and documented quality) of the AETB rather than on an extensive collection of prescriptive criteria that may or may not be relevant to a particular AETB. It also focuses on the education and qualifications of the individual tester.
    Note 5There has been an effort in the development of this Practice to keep the paperwork and administrative burdens on affected AETBs to the minimum required for an effective program.

    1. Scope

    1.1 This Practice specifies the general requirements for the competence to carry out sampling and analysis for air emissions tests of stationary sources. It covers testing and calibration performed using standard methods, non-standard methods and methods developed by the AETB.

    1.2 This Practice is applicable to all bodies engaged in air emission testing regardless of the number of personnel or the scope of testing activities. When an AETB does not undertake one or more of the activities covered by the Practice such as developing test methods, the requirements of those clauses do not apply.

    1.3 The notes given provide clarification of text, examples, and guidance. The notes do not contain requirements and do not form an integral part of this Practice.

    Note 1ISO/IEC 17025 has been considered when elaborating this Practice. Several, but not all, statements of this Practice are consistent with ISO 17025:2005.
    Note 2This Practice is a specification for competence. It does not address accreditation or any activities specific to accreditation such as on-site inspections/audits by external assessors or proficiency testing.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    Referenced Standards

    ISO17025 General Requirements for the Competence of Testing and Calibration Laboratories Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036.


    ICS Code

    ICS Number Code 13.040.01 (Air quality in general)

    UNSPSC Code

    UNSPSC Code 77121500(Air pollution)


    DOI: 10.1520/D7036-12

    ASTM International is a member of CrossRef.

    ASTM D7036

    Citing ASTM Standards
    Back to Top