ASTM D6848-02

    Standard Specification for Aluminum Pigmented Emulsified Asphalt Used as a Protective Coating for Roofing (Withdrawn 2011)

    Withdrawn Standard: ASTM D6848-02 | Developed by Subcommittee: D08.09

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    Withdrawn Rationale:

    This specification covers aluminum pigmented emulsified asphalt suitable for application as a protective coating for built-up roofs and other exposed surfaces by brush, roller, or spray application. The surfaces to which this product is applied are expected to have positive drainage as the coating is not anticipated for use where ponding conditions exist. The product is suitable for use on sheet metal, and smooth or granule surfaced emulsion, conventional BUR, and modified bitumen systems.

    Formerly under the jurisdiction of Committee D08 on Roofing and Waterproofing, this specification was withdrawn in July 2011 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This specification covers aluminum pigmented emulsified asphalt suitable for application as a protective coating for built-up roofs and other exposed surfaces by brush, roller, or spray application. The surfaces to which this product is applied are expected to have positive drainage as the coating is not anticipated for use where ponding conditions exist. The product is suitable for use on sheet metal, and smooth or granule surfaced emulsion, conventional BUR, and modified bitumen systems.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 The user is cautioned that aluminum pigmented emulsified asphalt may generate a reaction resulting in the evolution of hydrogen gas. Use caution when opening containers.

    1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B209 Specification for Aluminum and Aluminum-Alloy Sheet and Plate

    D562 Test Method for Consistency of Paints Measuring Krebs Unit (KU) Viscosity Using a Stormer-Type Viscometer

    D2824 Specification for Aluminum-Pigmented Asphalt Roof Coatings, Nonfibered, Asbestos Fibered, and Fibered Without Asbestos

    D2939 Test Methods for Emulsified Bitumens Used as Protective Coatings

    D6356 Test Method for Hydrogen Gas Generation of Aluminum Emulsified Asphalt Used as a Protective Coating for Roofing

    G154 Practice for Operating Fluorescent Light Apparatus for UV Exposure of Nonmetallic Materials


    Referencing This Standard

    DOI: 10.1520/D6848-02

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D6848-02, Standard Specification for Aluminum Pigmented Emulsified Asphalt Used as a Protective Coating for Roofing (Withdrawn 2011), ASTM International, West Conshohocken, PA, 2002, www.astm.org

    Back to Top