This test method covers the quantifying of the dynamic wiping efficiency of nonwoven fabrics.
This test method is being withdrawn with no replacement because D13 no longer has the technical expertise to maintain.
Formerly under the jurisdiction of Committee D13 on Textiles, this test method was withdrawn in October 2008.
1.1 This test method covers the quantifying of the dynamic wiping efficiency of nonwoven fabrics.
1.2 This test method applies to all nonwoven fabrics not used in cleanrooms.
Note 1—For dynamic wiping efficiency in cleanrooms, refer to Test Method D 6650 Standard Test Method for Determining the Dynamic Wiping Efficiency, Wet Particle Removal Ability, and Fabric Particle Contribution of Nonwoven Fabrics Used in Cleanrooms.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as the standard. Within the text, the inch-pound units are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
dynamic wiping efficiency; liquid removal; nonwoven fabrics; wipe-dry;
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]