Developed by Subcommittee: D19.06
WITHDRAWN, NO REPLACEMENT
This test method covers the detection of water and wastewater contaminants which inhibit chemiluminescence.
Formerly under the jurisdiction of Committee D19 on Water, this test method was withdrawn in February 2010 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
1.1 This test method covers the detection of water and wastewater contaminants which inhibit chemiluminescence.
1.2 This test method may be applied to ambient waters including but not exclusively river water and water from sewage treatment plants. It is the responsibility of the user of this standard to ensure the validity of the test method for waters of untested matrices.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D1129 Terminology Relating to Water
D1192 Specification for Equipment for Sampling Water and Steam in Closed Conduits
D1193 Specification for Reagent Water
D2777 Determination of Precision and Bias of Applicable Methods of Committee D19 on Water
D3370 Standard Practices for Committee D19 on Sampling Water
D3856 Standard Guide for Good Laboratory Practices in Laboratories Engaged in Sampling and Analysis of Water
D4210 Practice for Interlaboratory Quality Control Procedures and Discussion on Reporting Low Level Data
D5847 Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis