ASTM D6509 / D6509M - 09

    Standard Specification for Atactic Polypropylene (APP) Modified Bituminous Base Sheet Materials Using Glass Fiber Reinforcements

    Active Standard ASTM D6509 / D6509M | Developed by Subcommittee: D08.04

    Book of Standards Volume: 04.04


      Format Pages Price  
    PDF Version 3 $37.00   ADD TO CART
    Print Version 3 $37.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $44.40   ADD TO CART


    Abstract

    This specification covers prefabricated modified bituminous sheet materials with glass fiber reinforcement, which use atactic polypropylene (APP) as the primary modifier and which are intended for use as a base sheet in the fabrication of multiple ply roofing and waterproofing membranes. The high temperature stability and low temperature unrolling shall be tested to meet the requirements prescribed.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers prefabricated modified bituminous sheet materials with glass fiber reinforcement, which use atactic polypropylene (APP) as the primary modifier and which are intended for use as a base sheet in the fabrication of multiple ply roofing and waterproofing membranes.

    1.2 This is a material specification only. Issues regarding the suitability of specific roof constructions or application techniques are beyond the scope of this specification.

    1.3 The specified tests and property limits used to characterize the sheet materials covered by this specification are intended to establish minimum properties. In-place roof system design criteria, such as fire resistance, field strength, impact/puncture resistance, material compatibility, uplift resistance, the need for field applied coatings, and others, are factors beyond the scope of this material specification.

    1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.5 The following precautionary statement pertains only to the test method portion, Section 8, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1079 Terminology Relating to Roofing and Waterproofing

    D5147 Test Methods for Sampling and Testing Modified Bituminous Sheet Material

    D5636 Test Method for Low Temperature Unrolling of Felt or Sheet Roofing and Waterproofing Materials


    ICS Code

    ICS Number Code 83.120 (Reinforced plastics)

    UNSPSC Code

    UNSPSC Code 30121500(Bituminous derivatives); 30151500(Roofing materials)


    DOI: 10.1520/D6509_D6509M-09

    ASTM International is a member of CrossRef.

    ASTM D6509 / D6509M

    Citing ASTM Standards
    Back to Top