This practice details the standard procedure for evaluating the resistance of prestressed prepainted metal panels to cracking, or loss of adhesion, or both, after accelerated heat aging by dry heat test. This test method requires the use of gravity or forced air laboratory oven, bench vise, bending dies or test shims, 10x magnifier, and adhesive tape.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This practice can be used to evaluate the resistance of a prestressed prepainted metal panel to cracking, or loss of adhesion, or both, after accelerated heat aging. Most coil coated products are formed and bent into specific shapes to produce a final product. These operations introduce stresses, which may be relieved by cracking of the coating after aging.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Keywords

aging; coil; cracking; dry heat; fabrication; flexibility; heat aging; prepaint; pick-off; stresses; t-bend; Aging resistance; Dry heat tests; Prestressed prepainted metal;

ICS Code

ICS Number Code 87.020 (Paint coating processes)

Citing ASTM Standards

[Back to Top]