ASTM D6464 - 03a(2009)e1

    Standard Specification for Expandable Foam Adhesives for Fastening Gypsum Wallboard to Wood Framing

    Active Standard ASTM D6464 | Developed by Subcommittee: D14.70

    Book of Standards Volume: 15.06


      Format Pages Price  
    PDF 8 $42.00   ADD TO CART
    Hardcopy (shipping and handling) 8 $42.00   ADD TO CART
    Standard + Redline PDF Bundle 16 $50.40   ADD TO CART


    Abstract

    This specification establishes minimum performance requirements for determining strength, aging, and working properties of expandable foam adhesives intended for bonding back surfaces of gypsum wallboards of all thicknesses to wood framing. Minimum physical and performance requirements are specified for all measured properties of adhesives and adhesive bonds. Shear strength, tensile strength, adhesive open assembly time determination, substrate wet-out by adhesive, accelerated adhesive aging, freeze-thaw stability, suitability of a laminating adhesive for vinyl-covered wallboard, suitability for stain resistance for vinyl-covered wallboard, and gap filling tests shall be performed to conform to the specified requirements.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    Significance and Use

    1. Scope

    1.1 This specification establishes minimum performance requirements for determining strength, aging, and working properties of expandable foam adhesives intended for bonding back surfaces of gypsum wallboards of all thicknesses to wood framing. Minimum physical and performance requirements are specified for all measured properties of adhesives and adhesive bonds.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C1396/C1396M Specification for Gypsum Board

    D905 Test Method for Strength Properties of Adhesive Bonds in Shear by Compression Loading

    D907 Terminology of Adhesives

    E4 Practices for Force Verification of Testing Machines

    E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods


    ICS Code

    ICS Number Code 49.025.50 (Adhesives)

    UNSPSC Code

    UNSPSC Code 31201608(Foam adhesives)


    DOI: 10.1520/D6464-03AR09E01

    ASTM International is a member of CrossRef.

    ASTM D6464

    Citing ASTM Standards
    Back to Top