WITHDRAWN, NO REPLACEMENT
| ||Format||Pages||Price|| |
|4||$48.00||  ADD TO CART|
This test method covers the determination of the total sulfur naturally found in liquid aromatic hydrocarbons, their derivatives and related chemicals.
Formerly under the jurisdiction of Committee D16 on Aromatic Hydrocarbons and Related Chemicals, this test method was withdrawn in June 2006 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
1.1 This test method covers the determination of the total sulfur naturally found in liquid aromatic hydrocarbons, their derivatives and related chemicals.
1.2 This test method is applicable for samples containing sulfur from 0.05 to 100 mgS/kg.
1.3 The detector response for this technique within the scope of this test method is linear with sulfur concentration.
1.4 The following applies to all specified limits in this test method for purposes of determining conformance with this test method, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 9, and Notes 2-4 and Note 7.
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D6428-99, Test Method for Total Sulfur in Liquid Aromatic Hydrocarbons and Their Derivatives by Oxidative Combustion and Electrochemical Detection (Withdrawn 2006), ASTM International, West Conshohocken, PA, 1999, www.astm.orgBack to Top