ASTM D6369 - 99(2006)

    Standard Guide for Design of Standard Flashing Details for EPDM Roof Membranes

    Active Standard ASTM D6369 | Developed by Subcommittee: D08.18

    Book of Standards Volume: 04.04


      Format Pages Price  
    PDF 14 $49.00   ADD TO CART
    Hardcopy (shipping and handling) 14 $49.00   ADD TO CART


    Significance and Use

    This guide illustrates general details for typical conditions that may be encountered on an EPDM sheet roofing system.

    This guide does not address all requirements associated with the installation of EPDM membrane flashing, such as membrane cleaning and surface preparation, fastener spacing, adhesive application and other seaming requirements which may vary by membrane system supplier.

    Insulation, fastener types, protection mats, stone ballast, pavers, and requirements for perimeter attachment are not covered by this guide. The designer shall review the project requirements and consult the membrane system supplier, building insurer, and local building codes for specific requirements.

    1. Scope

    1.1 This guide covers the design of details for typical conditions encountered in new ballasted, mechanically attached or fully adhered ethylene propylene diene terpolymer (EPDM) sheet roof systems.

    1.2 This guide illustrates general details for typical conditions that may be encountered on an EPDM sheet roofing system. The guide will assist the designer in preparing details for each specific condition that may occur on a project.

    1.3 The values stated in SI units are to be regarded as standard. The conventional units given in parentheses are provided for information purposes only.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1079 Terminology Relating to Roofing and Waterproofing


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials)

    UNSPSC Code

    UNSPSC Code 13101600(Processed and synthetic rubber); 30151602(Flashings)


    Referencing This Standard

    DOI: 10.1520/D6369-99R06

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D6369-99(2006), Standard Guide for Design of Standard Flashing Details for EPDM Roof Membranes, ASTM International, West Conshohocken, PA, 2006, www.astm.org

    Back to Top