ASTM D6269-98e1

    Test Method for Solidification Point of p-Xylene (Withdrawn 2004)

    Withdrawn Standard: ASTM D6269-98e1 | Developed by Subcommittee: D16.04

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    Withdrawn Rationale:

    This test method covers the determination of the solidification point of p-Xylene with purity greater than 99.5 %.

    Formerly under the jurisdiction of Committee D16 on Aromatic Hydrocarbons and Related Materials, this test method was withdrawn in December 2004 in accordance with section 10.6.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This test method covers the determination of the solidification point of p-Xylene with purity greater than 99.5 %.

    Note 1—Other test methods for determining freeze point and solidification point of aromatic hydrocarbons include Test Methods D 852, D 1015, D 1016, and D 1493.

    1.2 The following applies to all specified limits in this test method: for purposes of determining conformance with this test method, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.

    1.3 This standard does not purport to address all the safety concerns, if any, associated with its use. It is the responsibility of the user of this test method to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 7.



    DOI: 10.1520/D6269-98E01

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D6269-98e1, Test Method for Solidification Point of p-Xylene (Withdrawn 2004), ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top