WITHDRAWN, NO REPLACEMENT
| ||Format||Pages||Price|| |
|5||$51.60||  ADD TO CART|
This practice is applicable to a wide range of virgin pulps or pulps derived from recovered materials or recovered paper of the type typically used to produce paper, paperboard and other paper products.
Formerly under the jurisdiction of Committee D06 on Paper and Paper Products, this practice was withdrawn in August 2010 because an equivalent TAPPI publication exists.
1.1 This practice is applicable to a wide range of virgin pulps or pulps derived from recovered materials or recovered paper of the type typically used to produce paper, paperboard and other paper products.
1.2 This practice describes laboratory procedures whereby stickies are typically separated from pulp fibers, and then the separated stickies fraction is examined by qualitative or quantitative procedures, or both.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D585 Practice for Sampling and Accepting a Single Lot of Paper, Paperboard, Fiberboard, and Related Product
D1968 Terminology Relating to Paper and Paper Products
D2019 Test Method for Dirt in Paper and Paperboard
E122 Practice for Calculating Sample Size to Estimate, With a Specified Tolerable Error, the Average for Characteristic of a Lot or Process
TAPPI DocumentsUM242 Shive Content in Mechanical Pulp (Somerville Fractionator)
ASTM D6148-97(2007), Standard Practice for Separation and Examination of Stickies (Withdrawn 2010), ASTM International, West Conshohocken, PA, 2007, www.astm.orgBack to Top