Abstract
Test
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Significance and Use
4. Significance and Use
4.1 The procedures described in this practice are designed to provide steel panels with a uniform and reproducible surface for testing of paint, varnish, lacquer, conversion coatings, and related products.
1. Scope
1.1 This practice covers various types of cold rolled steel panels and the procedures to be followed in their preparation for testing paint, varnish, lacquer, conversion coatings, and related products.
1.2 The procedures are as follows:
Procedure A???Conversion coatings (phosphates, chromates,
etc.)
Procedure B???Vapor degreasing
Procedure C???Solvent brushing
Procedure D???Solvent wiping
Procedure E???Alkaline cleaning
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A109/A109M Specification for Steel, Strip, Carbon (0.25 Maximum Percent), Cold-Rolled
A366/A366M Specification for Commercial Steel (CS), Sheet, Carbon (0.15 Maximum Percent), Cold-Rolled
D235 Specification for Mineral Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent)
Keywords
panels; sheet metal; steel panels; substrate-coatings application ;
ICS Code
ICS Number Code 77.140.50 (Flat steel products and semi-products)
DOI: 10.1520/D0609-00R12
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
