ASTM D585-97(2007)

    Standard Practice for Sampling and Accepting a Single Lot of Paper, Paperboard, Fiberboard, and Related Product (Withdrawn 2010)

    Withdrawn Standard: ASTM D585-97(2007) | Developed by Subcommittee: D06.92

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF Version 5 $50.40   ADD TO CART


    Withdrawn Rationale:

    This practice covers a procedure for obtaining a sample to represent a lot of paper or paperboard, fiberboard, or related product, including converted paper products (all hereafter referred to as paper).

    Formerly under the jurisdiction of Committee D06 on Paper and Paper Products, this practice was withdrawn in May 2010 because equivalent TAPPI and ISO publications exist.

    1. Scope

    1.1 This practice covers a procedure for obtaining a sample to represent a lot of paper or paperboard, fiberboard, or related product, including converted paper products (all hereafter referred to as paper).

    1.2 Prior to purchase, there should be agreement between buyer and seller on the size of the lot to be sampled (), on details of the sampling procedure, the required physical and chemical properties, dimensional tolerances, etc., and the test methods to be employed.

    1.3 Appendix X1and Appendix X2, which provide useful, statistical criteria for accepting individual lots of paper on the basis of the number of defective test units, can assist the buyer and the seller in selecting an agreed-upon sampling and acceptance procedure.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D528 Test Method for Machine Direction of Paper and Paperboard

    D1968 Terminology Relating to Paper and Paper Products

    D5039 Test Methods for Identification of Wire Side of Paper

    ISO Standard

    ISO186 Paper and Board-Sampling for Testing

    Military Standards

    MIL-STD-414 Sampling Procedure and Table for Inspection by Variables for Percent Defective


    DOI: 10.1520/D0585-97R07

    ASTM International is a member of CrossRef.