ASTM D5843 / D5843M - 95(2014)e1

    Standard Guide for Application of Fully Adhered Vulcanized Rubber Sheets Used in Waterproofing

    Active Standard ASTM D5843 / D5843M | Developed by Subcommittee: D08.22

    Book of Standards Volume: 04.04


      Format Pages Price  
    PDF 3 $38.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $38.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $45.60   ADD TO CART


    1. Scope

    1.1 This guide provides information to assist the specifier in developing a specification for the application and protection of fully adhered EPDM (elastomeric terpolymer synthesized from ethylene, propylene and diene monomer), butyl, and neoprene vulcanized rubber sheets to be installed on concrete substrates.

    1.2 The structure and the deck should be evaluated, and found to be mechanically sound, able to accept the weight of the sheet and overburden, and meet the local building code requirements.

    1.3 The deck should be sloped to drain with a drainage media or layer above the membrane. The drainage media or layer is not addressed in this guide.

    1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    UNSPSC Code

    UNSPSC Code 30266402(Rubber sheet); 30151500(Roofing materials)


    Referencing This Standard

    DOI: 10.1520/D5843-95R14E01

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D5843 / D5843M-95(2014)e1, Standard Guide for Application of Fully Adhered Vulcanized Rubber Sheets Used in Waterproofing, ASTM International, West Conshohocken, PA, 2014, www.astm.org

    Back to Top