This test method is designed to determine the purity of p-phenylenediamine antidegradants.

Since the results of this test method are based on an integrated peak area as determined by HPLC, it is assumed that all analytes of interest are resolved from interfering peaks.

1. Scope

1.1 This test method covers the purity of Type I, II, and III p-phenylenediamine (PPD) antidegradants as described in Classification D 4676 by high performance liquid chromatography (HPLC) using ultraviolet detection and external standard calculations.

1.2 Expertise in HPLC is necessary to the successful application of this test method.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

ISO Standards

Keywords

antidegradant; high performance liquid chromatography; N-isopropl-N′-phenyl-p-phenylenediamine (IPPD); N-(1, 3 dimethylbutyl)-N′-phenyl-p-phenylenediamine (6PPD); N, N′ bis-(1, 4-dimethylpentyl)-p-phenylenediamine (77PD); N, N′-ditolyl-p-phenylenediamine (DTPD); p-phenylenediamine (PPD); Antidegradants; HPLC (high performance liquid chromatography); Liquid chromatography (LC); PPD (p-phenylenediamine); Purity analysis--rubber materials;

ICS Code

ICS Number Code 71.100.45 (Refrigerants and antifreezes)

Citing ASTM Standards

[Back to Top]