This test method is used to determine the grading of aggregates extracted from bituminous mixtures. The results are used to determine compliance of the particle size distribution with applicable specifications requirements, and to provide necessary data for control of the production of various aggregates to be used in bituminous mixtures.

1. Scope

1.1 This test method covers a procedure for determination of the particle size distribution of fine and coarse aggregates extracted from bituminous mixtures using sieves with square openings.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C670 Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials

D2172 Test Methods for Quantitative Extraction of Bitumen From Bituminous Paving Mixtures

D6307 Test Method for Asphalt Content of Hot-Mix Asphalt by Ignition Method

E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

AASHTO Standard

Keywords

aggregate; extraction; gradation; Aggregate; Extracted aggregate; Gradation; Mechanical analysis/testing; Particle analysis--aggregate; Size/size distribution analysis;

ICS Code

ICS Number Code 19.120 (Particle size analysis. Sieving)

Citing ASTM Standards

[Back to Top]