ASTM D5339-94(1998)

    Standard Practice for Quality Assurance Plan for Structural Steel Fabrication for Highway Structures (Withdrawn 2005)

    Withdrawn Standard: ASTM D5339-94(1998) | Developed by Subcommittee: D04.32

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    Withdrawn Rationale:

    This practice establishes procedures for a quality assurance plan for structural steel fabrication for highway structures. These procedures pertain to the inspections, measurements, and tests necessary for the fabricator and owner to substantiate material and product conformance to contract requirements. The fabricator's quality control plan (QCP) is to be designed and implemented with the objective of ensuring that all materials incorporated into the work conform to contract requirements. The owners acceptance testing plan (ATP) is designed to provide assurance that the fabricator has successfully met this objective.

    Formerly under the jurisdiction of Committee D04 on Road and Paving Materials, this practice was withdrawn in June 2005 due to lack of use by the industry.

    1. Scope

    1.1 This practice establishes procedures for a quality assurance plan for structural steel fabrication for highway structures. These procedures pertain to the inspections, measurements, and tests necessary for the fabricator and owner to substantiate material and product conformance to contract requirements. The fabricator's quality control plan (QCP) is to be designed and implemented with the objective of ensuring that all materials incorporated into the work conform to contract requirements. The owners acceptance testing plan (ATP) is designed to provide assurance that the fabricator has successfully met this objective.

    1.2 Inherent in this practice is the assumption that design details and specifications allow maximum flexibility in procedures and processes to allow the most cost-effective fabrication to be performed consistent with the quality level specified.

    1.3 Alternative sampling methods, processes, procedures, and inspection equipment may be used by the fabricator when such procedures and equipment provide, as a minimum, the quality assurance required by the contract documents. Prior to applying such alternative procedures, the fabricator is to describe the procedure in a written proposal, and demonstrate to the satisfaction of the owner that the effectiveness of these alternative procedures are equal to or better than the contract requirements. In case of dispute, the procedures stipulated in the contract documents will apply.



    Referencing This Standard

    DOI: 10.1520/D5339-94R98

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D5339-94(1998), Standard Practice for Quality Assurance Plan for Structural Steel Fabrication for Highway Structures (Withdrawn 2005), ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top