ASTM D5180-93(1998)

    Standard Test Method for Quantitative Test for Turbidity in Clear Liquids (Withdrawn 2007)

    Withdrawn Standard: ASTM D5180-93(1998) | Developed by Subcommittee: D01.33

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 2 $45.60   ADD TO CART


    Withdrawn Rationale:

    This test method covers the measurement of turbidity of clear liquids. It is applicable to resin solutions, solvents, clear coatings, monomers, and any other liquids where clarity is specified. This test method should be used only for comparison of clarity of similar materials, and not to obtain absolute values for turbidity.

    Formerly under the jurisdiction of Committee D01 on Paint and Related Coatings, Materials, and Applications, this test method was withdrawn in March 2007 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This test method covers the measurement of turbidity of clear liquids. It is applicable to resin solutions, solvents, clear coatings, monomers, and any other liquids where clarity is specified. This test method should be used only for comparison of clarity of similar materials, and not to obtain absolute values for turbidity.

    1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    Referencing This Standard

    DOI: 10.1520/D5180-93R98

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D5180-93(1998), Standard Test Method for Quantitative Test for Turbidity in Clear Liquids (Withdrawn 2007), ASTM International, West Conshohocken, PA, 1993, www.astm.org

    Back to Top