Significance and Use
This test method provides a means of determining the palladium content in fresh catalysts containing molecular sieves.
This test method is not intended to cover samples containing precious metals other than palladium.
1.1 This test method covers the determination of palladium in molecular sieve-containing fresh catalysts with about 0.5 weight % of palladium.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D1193 Specification for Reagent Water
D7442 Practice for Sample Preparation of Fluid Catalytic Cracking Catalysts and Zeolites for Elemental Analysis by Inductively Coupled Plasma Atomic Emission Spectroscopy
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E456 Terminology Relating to Quality and Statistics
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
U.S. Federal Specification
FederalSpec.NNN-P-39 Tolerance for Class A Pipets Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098.
atomic absorption; molecular sieve; molecular sieve catalyst; palladium; Catalysts/catalyst carriers; Molecular sieve catalyst; Palladium; Spectrophotometry--atomic absorption (petroleum);
ICS Number Code 71.040.30 (Chemical reagents)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]