ASTM D5140-95

    Withdrawn Standard: ASTM D5140-95 Standard Guide for Testing Polyurethane Poured in Place Thermal Break Materials (Withdrawn 2004)

    Developed by Subcommittee: D20.24

    WITHDRAWN, NO REPLACEMENT

    Buy Standard (PDF)
    2 pages
    $44.40


    Withdrawn Rationale:

    This guide covers the preparation of a standard-size test sample and basic tests for physical property determinations of solid thermal break materials.

    Formerly under the jurisdiction of Committee D20 on Plastics, this guide was withdrawn in July 2004. This guide was withdrawn in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This guide covers the preparation of a standard-size test sample and basic tests for physical property determinations of solid thermal break materials.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    Note 1-There is no similar or equivalent ISO standard.

    1.3 The following precautionary caveat pertains only to the test method portion, Sections 6 through 14, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    DOI: 10.1520/D5140-95

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top