WITHDRAWN, NO REPLACEMENT
| ||Format||Pages||Price|| |
|2||$46.80||  ADD TO CART|
This practice covers the minimum requirements for the installation of mechanically attached poly(vinyl chloride) roofing.
Formerly under the jurisdiction of Committee D08 on Roofing and Waterproofing, this practice was withdrawn in July 2012 due to limited use by the industry.
1.1 This practice covers the minimum requirements for the installation of mechanically attached poly(vinyl chloride) roofing.
1.2 For the purpose of this application practice, the structure and deck are assumed to be mechanically sound, able to accept the weight of the membrane and other roofing system materials, comply with local building codes, and other roofing requirements. The insulation layer(s) and vapor retarder, if specified, are assumed to be in place, secured, and acceptable for use with the membrane.
1.3 This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D1079 Terminology Relating to Roofing and Waterproofing
D4434 Specification for Poly(Vinyl Chloride) Sheet Roofing
Other StandardsFactory Mutual Research Corporation Approval Stand Class I Roof Covers, April 1986 Available from Factory Mutual Research Corp., 1151 Boston-Providence Turnpike, Norwood, MA 02062.
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D5082-99(2005), Standard Practice for Application of Mechanically Attached Poly(Vinyl Chloride) Sheet Roofing (Withdrawn 2012), ASTM International, West Conshohocken, PA, 2005, www.astm.orgBack to Top