ASTM D5039-97(2002)

    Withdrawn Standard: ASTM D5039-97(2002) Standard Test Methods for Identification of Wire Side of Paper (Withdrawn 2009)

    Developed by Subcommittee: D06.92

    WITHDRAWN, NO REPLACEMENT

    Buy Standard (PDF)
    2 pages
    $44.40


    Withdrawn Rationale:

    The test methods describe procedures for identifying the wire side of paper made on a one-wire fourdrinier paper machine.

    Formerly under the jurisdiction of Committee D06 on Paper and Paper Products, these test methods were withdrawn in September 2009 due to insufficient committee interest in reviewing and revising the standard.

    1. Scope

    1.1 The test methods describe procedures for identifying the wire side of paper made on a one-wire fourdrinier paper machine.

    1.2 It is desirable to have means of distinguishing between the two sides because they generally differ in some physical and chemical characteristics. It is not always possible to identify the sides, particularly with coated and other surface-treated papers, certain high-grade papers made from well-beaten rag stock and specialties made with variations in the usual paper-making practices. If one procedure does not give a definite identification, the other procedures should be tried. Nevertheless, if any one of the following procedures gives a clear result, identification is established.

    1.3 The procedures in these test methods are not applicable to paper made on cylinder, twin-wire, or other special machines.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1968 Terminology Relating to Paper and Paper Products


    DOI: 10.1520/D5039-97R02

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top