ASTM D5019-07a

    Standard Specification for Reinforced CSM (Chlorosulfonated Polyethylene) Sheet Used in Single-Ply Roof Membrane (Withdrawn 2011)

    Withdrawn Standard: ASTM D5019-07a | Developed by Subcommittee: D08.18

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    Withdrawn Rationale:

    This specification covers reinforced non-vulcanized polymeric sheet made from chlorosulfonated polyethylene (CSM) intended for use as a single-ply roof membrane exposed to the weather. The sheet shall be reinforced with fiber or fabric.

    Formerly under the jurisdiction of Committee D08 on Roofing and Waterproofing, this specification was withdrawn in May 2011 because the product is no longer manufactured.

    1. Scope

    1.1 This specification covers reinforced non-vulcanized polymeric sheet made from chlorosulfonated polyethylene (CSM) (see Note 1 ) intended for use as a single-ply roof membrane exposed to the weather. The sheet shall be reinforced with fiber or fabric.

    Note 1

    The term CSPE for chlorosulfonated polyethylene is commonly used in the roofing industry.

    1.1.1 The polymers used in these sheets have thermoplastic characteristics at time of installation. The chlorosulfonated polyethylene will vulcanize in place under ambient conditions.

    1.2 The tests and property limits used to characterize these sheets are minimum values.

    1.2.1 In-place roof systems design criteria such as fire resistance, field seaming strength, impact/puncture resistance, material compatibility, and uplift resistance, among others, are factors that must be considered, but are beyond the scope of this specification.

    1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.4 The following precautionary caveat pertains to the test methods portion only, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

    D413 Test Methods for Rubber Property--Adhesion to Flexible Substrate

    D471 Test Method for Rubber Property--Effect of Liquids

    D518 Test Method for Rubber Deterioration--Surface Cracking

    D751 Test Methods for Coated Fabrics

    D1004 Test Method for Tear Resistance (Graves Tear) of Plastic Film and Sheeting

    D1149 Test Methods for Rubber Deterioration--Cracking in an Ozone Controlled Environment

    D1204 Test Method for Linear Dimensional Changes of Nonrigid Thermoplastic Sheeting or Film at Elevated Temperature

    D2136 Test Method for Coated Fabrics--Low-Temperature Bend Test

    G151 Practice for Exposing Nonmetallic Materials in Accelerated Test Devices that Use Laboratory Light Sources

    G155 Practice for Operating Xenon Arc Light Apparatus for Exposure of Non-Metallic Materials


    Referencing This Standard

    DOI: 10.1520/D5019-07A

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D5019-07a, Standard Specification for Reinforced CSM (Chlorosulfonated Polyethylene) Sheet Used in Single-Ply Roof Membrane (Withdrawn 2011), ASTM International, West Conshohocken, PA, 2007, www.astm.org

    Back to Top