Active Standard ASTM D4880 | Developed by Subcommittee: D09.01
Book of Standards Volume: 10.02
Historical (view previous versions of standard)
Significance and Use
This test method is useful in determining the performance of varnishes over enamelled magnet wire when subjected to the specified sodium chloride solution. It is useful in evaluating the resistance of varnished magnet wire to a diluted sodium chloride solution under applied voltage.
1.1 This test method covers the performance in a specified water solution of an insulating varnish applied over enamelled magnet wire.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 6. Note 1—There is no IEC method equivalent to this standard.
Note 1—There is no IEC method equivalent to this standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D1676 Test Methods for Film-Insulated Magnet Wire
D1711 Terminology Relating to Electrical Insulation
ICS Number Code 29.035.60 (Varnished fabrics)
UNSPSC Code 26121509(Magnet wire); 31211707(Varnishes)