Active Standard ASTM D4866 / D4866M | Developed by Subcommittee: D08.09
Book of Standards Volume: 04.04
Historical (view previous versions of standard)
1.1 This performance specification covers mixtures of emulsified coal-tar pitch (mineral colloid type), mineral aggregates, and optional polymeric admixtures that are used as a weather-protective and straight aliphatic hydrocarbon resistant coatings over bituminous pavements of airports, parking areas, and driveways.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 The following safety hazards statement applies only to the test method portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D466 Test Methods for Films Deposited From Bituminous Emulsions
D2939 Test Methods for Emulsified Bitumens Used as Protective Coatings
D3699 Specification for Kerosine
D5727 Specification for Emulsified Refined Coal Tar (Mineral Colloid Type)
ICS Number Code 93.080.20 (Road construction materials)
UNSPSC Code 30121602(Pitch); 30111800(Aggregates)