ASTM D4782 - 10

    Standard Test Method for Palladium in Molecular Sieve Catalyst by Wet Chemistry

    Active Standard ASTM D4782 | Developed by Subcommittee: D32.03

    Book of Standards Volume: 05.05


    Buy Standard (PDF)
    4 pages
    $37.00
    Buy Standard (Print)
    4 pages
    $37.00
    Buy Standard + Redline (PDF)
    8 pages
    $44.40

    Historical (view previous versions of standard)


    ASTM D4782

    Significance and Use

    This test method provides a means of determining the palladium content in fresh catalysts containing molecular sieves.

    This test method is not intended to cover samples containing metals other than palladium.

    1. Scope

    1.1 This test method covers the determination of palladium in molecular sieve-containing fresh catalysts with about 0.5 weight % of palladium.

    1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1193 Specification for Reagent Water

    D7442 Practice for Sample Preparation of Fluid Catalytic Cracking Catalysts and Zeolites for Elemental Analysis by Inductively Coupled Plasma Atomic Emission Spectroscopy

    E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods

    E456 Terminology Relating to Quality and Statistics

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method


    UNSPSC Code

    UNSPSC Code


    DOI: 10.1520/D4782-10

    ASTM International is a member of CrossRef.

    ASTM D4782

    Citing ASTM Standards
    Back to Top