ASTM D4770/D4770M-00(2007)

    Standard Test Method for Appearance and Integrity of Highloft Batting After Refurbishing (Withdrawn 2008)

    Withdrawn Standard: ASTM D4770/D4770M-00(2007) | Developed by Subcommittee: D13.90

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    Withdrawn Rationale:

    This test method covers procedures for determining the tactile appearance and integrity of a highloft nonwoven batting after machine washing or drycleaning when tested in a finished product or a panel assembly simulating the construction of the finished product.

    This standard is being withdrawn with no replacement because D13 no longer has the technical expertise to maintain.

    Formerly under the jurisdiction of ASTM Committee D13 on Textiles, this test method was withdrawn in October 2008.

    1. Scope

    1.1 This test method covers procedures for determining the tactile appearance and integrity of a highloft nonwoven batting after machine washing or drycleaning when tested in a finished product or a panel assembly simulating the construction of the finished product.

    1.2 This test method is not intended for use on wool/wool blend and cotton/cotton blend batting and needle-punched structures.

    1.3 This test method provides the values in both SI units and inch-pound units. "Inch-pound units" is the technically correct name for the customary units used in the United States. "SI units" is the technically correct name for the system of metric units known as the International System of Units. The values stated in either system of units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining in any way.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    Referencing This Standard

    DOI: 10.1520/D4770_D4770M-00R07

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D4770 / D4770M-00(2007), Standard Test Method for Appearance and Integrity of Highloft Batting After Refurbishing (Withdrawn 2008), ASTM International, West Conshohocken, PA, 2007, www.astm.org

    Back to Top