ASTM D4601 / D4601M - 04(2012)e1

    Standard Specification for Asphalt-Coated Glass Fiber Base Sheet Used in Roofing

    Active Standard ASTM D4601 / D4601M | Developed by Subcommittee: D08.04

    Book of Standards Volume: 04.04


    Buy Standard (PDF)
    3 pages
    $37.00
    Buy Standard (Print)
    3 pages
    $37.00
    Buy Standard + Redline (PDF)
    6 pages
    $44.40

    Historical (view previous versions of standard)


    ASTM D4601 / D4601M

    Abstract

    This specification covers the standards for asphalt impregnated and coated glass fiber base sheet intended for use as the first ply of built-up roofings. This sheets are also suitable for use as a vapor retarded under roof insulation or between multiple layers of roof insulation. The materials shall conform to the physical requirements, dimensions, and masses prescribed herein. The products shall not crack nor be too sticky as to cause damage upon being unrolled. The specimen shall also undergo testing to determine the following properties: breaking strength, moisture content, and pliability.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers asphalt impregnated and coated glass fiber base sheet, with or without perforations, for use as the first ply of the built-up roofing. When not perforated, this sheet is suitable for use as a vapor retarder, with a solid mopping of asphaltic material, under roof insulation or between multiple layers of roof insulation.

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D146 Test Methods for Sampling and Testing Bitumen-Saturated Felts and Woven Fabrics for Roofing and Waterproofing

    D228 Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing

    D1079 Terminology Relating to Roofing and Waterproofing


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials)

    UNSPSC Code

    UNSPSC Code 30121601(Asphalt); 30151500(Roofing materials)


    DOI: 10.1520/D4601_D4601M-04R12E01

    ASTM International is a member of CrossRef.

    ASTM D4601 / D4601M

    Citing ASTM Standards
    Back to Top