This test method is used to determine the grading of materials used as granular mineral surfacing. The results are used to determine compliance of the particle size distribution with applicable specification requirements.

1. Scope

1.1 This test method covers the determination of the particle size distribution of granular mineral surfacing material such as crushed slate, stone, coated granules, and so forth, used on the weather surface of prepared asphalt roofing and shingles.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

Keywords

asphalt roofing; mineral surfacing; particle size distribution; sieve analysis; Asphalt roofing materials; Mineral-asphalt mixtures; Particle analysis--roofing materials; Sieve analysis--asphalts; Surfacings;

ICS Code

ICS Number Code 91.100.15 (Mineral materials and products)

Citing ASTM Standards

[Back to Top]