ASTM D4372-93

    Standard Specification for Flame-Resistant Materials Used in Camping Tentage (Withdrawn 2002)

    Withdrawn Standard: ASTM D4372-93 | Developed by Subcommittee: D13.52

    WITHDRAWN, NO REPLACEMENT


    There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
    (Click here to view IHS phone and email contact details).



    1. Scope

    1.1 This specification covers the evaluation of the flame resistance of fabric and other pliable materials used in camping tentage.

    1.2 It provides for certification of materials by suppliers and for labeling programs to caution the user against actions detrimental to flame-retardant treated fabrics. It also facilitates the identification of tentage as being constructed of flame-resistant materials, and it identifies the manufacturer.

    1.3 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.

    1.4 The following precautionary caveat pertains only to the test method portion, Sections 8 and 9, of this specification:

    1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    Referencing This Standard

    DOI: 10.1520/D4372-93

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D4372-93, Standard Specification for Flame-Resistant Materials Used in Camping Tentage (Withdrawn 2002), ASTM International, West Conshohocken, PA, 1993, www.astm.org

    Back to Top