ASTM D4314 - 12

    Standard Specification for General-Purpose, Heavy-Duty, and Extra-Heavy-Duty Crosslinked Chlorosulfonated Polyethylene (CSM) Jackets For Wire and Cable

    Active Standard ASTM D4314 | Developed by Subcommittee: D09.18

    Book of Standards Volume: 10.02


      Format Pages Price  
    PDF Version 2 $37.00   ADD TO CART
    Print Version 2 $37.00   ADD TO CART
    Standard + Redline PDF Bundle 4 $44.40   ADD TO CART


    Abstract

    This specification covers the standard requirements for crosslinked chlorosulfonated polyethylene compounds intended for use as jacket materials (outer coverings) on electrical wires and cables for general-purpose, heavy-duty, and extra-heavy-duty service. The materials under this specification, however, are not recommended for applications with very low temperature service requirement. Physical tests shall be performed to assess the conformance of the jacket material with the physical property requirements such as tensile strength, tensile stress at elongation, elongation at rupture, tension set, and tear. Per service requirement, additional tests for sunlight and weather resistance shall be performed as well, and shall conform to the requirements specified.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers crosslinked chlorosulfonated polyethylene compounds suitable for use as outer coverings or jackets on electrical cables for general-purpose, heavy-duty, and extra-heavy-duty service.

    1.2 These jacket materials are not recommended for cables installed at a temperature lower than 25°C.

    1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D470 Test Methods for Crosslinked Insulations and Jackets for Wire and Cable

    D1248 Specification for Polyethylene Plastics Extrusion Materials for Wire and Cable

    D1711 Terminology Relating to Electrical Insulation


    ICS Code

    ICS Number Code 29.035.20 (Plastic and rubber insulating materials)

    UNSPSC Code

    UNSPSC Code 26121500(Electrical wire); 13111016(Polyethylene)


    DOI: 10.1520/D4314-12

    ASTM International is a member of CrossRef.

    ASTM D4314

    Citing ASTM Standards
    Back to Top