ASTM D4248-98(2003)

    Standard Practice for Design of Steam Turbine Generator Oil Systems (Withdrawn 2008)

    Withdrawn Standard: ASTM D4248-98(2003) | Developed by Subcommittee: D02.C0.01

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 4 $44.40   ADD TO CART


    Withdrawn Rationale:

    This practice is applicable to steam turbine-generator units and provides recommended practices for the design of the oil system.

    This practice is being withdrawn due to lack of interest and support for its continued use.

    Formerly under the jurisdiction of Committee D02 on Petroleum Products and Lubricants, this practice was withdrawn in October 2008.

    1. Scope

    1.1 This practice is applicable to steam turbine-generator units and provides recommended practices for the design of the oil system.

    1.1.1 The oil system is defined as that assembly which uses and circulates the turbine-generator lubricating oil. The oil system generally includes high pressure, bearing, control, generator seal, and drain systems. The system may also include the supply and return lines for a boiler feed pump and hydraulic coupling.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    DOI: 10.1520/D4248-98R03

    ASTM International is a member of CrossRef.